The slot with the glass in it.
Cutting the slot on my table saw was a bit nerve racking as all the curves and molding were already cut, I didn't even try to cut it to the full depth in one shot, probably did about 15 cuts raising the blade a bit each time.
Cutting the door side rails to length presented another problem, they were way too long for my table saw and I don't have a full scale table saw and my pieces weren't the same length either. in the end I taped a piece of wood to the arm on my band saw and cut all eight side rails to the same length but still a bit overlong.
The last little bit I cut off on the table saw because I wanted a really smooth cut.
The panel for the bottom of the door was slightly too big and I had to remove about 0.5mm on all four sides, with the angle in the middle rail this was all quite complicated to cut and fit.
One of the four doors in the frame to check that the height is right.
I also checked that the glass and small rails will fit right, I am using microscope slides as they are nice and thin and I was lucky enough that they fit perfectly height wise, now I need to cut the glass and the wooden rails to size before any gluing can be done.
I also took time off from my orders to build two pieces of furniture, I had a deadline and finished both of these in eleven days. The first is a 19th century French washstand, the original was build from pine, I used Oregon pine for mine.
And here is the original full scale washstand that I copied.
The original was made from Rosewood, I made mine from some mahogany sheets that I had because I didn't have time to cut and sand the wood I really want to use for this, a South African wood called Candlewood, it has a very nice grain and color that resembles Rosewood very well and I will make some again later this year in the Candlewood.
The reason for the rush, they were for class proposals, I will be teaching for the first time later this year, looking forward to it and kind of dreading it at the same time, first time nerves I guess! I will tell you later when and where when all the details has been loaded onto the website.
Have a great week